This lab will be done using Logicly

In this lab, we are going to design and extend our previous 4-bit full adder using the register. Our new adder runs in two modes and stores the result in the register. In the first mode it takes both of the inputs (4-bits) like what weve implemented before and stores the result in the register. In the second mode, it takes only one input while taking another one from the current value stored in the register and stores the new result back. For the register, you can use D flip flop (use a toggle switch as clock to control the writing operation), and you are free to use any component we learned in our previous labs. In order to take the last carry (fifth-bit) into your design, create a register for it like other bits, which results in storing 5-bits in the registers correspondingly. Finally connect registers to the light bulbs to show the output results. For example, in mode 1, A=0001, B=1010; after toggling the clock switch (rising edge), your registers and your light bulbs represent 01011, then continuing from current state, in mode 2, A=0001 you will get 01100 in registers and light bulbs. Complete the following 4 steps and take screenshot of your circuit and the output youve got (You have to start from step 1 and finish in step 5 in order, i.e., step 2 starts after step 1 is finished and so on). 1: Mode 1, Inputs: A=0001, B=0101 2: Mode 2, Inputs: A=0010 3: Mode 2, Inputs: A=0110 4: Mode 2, Inputs: A=0100 5: Mode 2, Inputs: A=0001 Please make sure you submit a screenshot of your completed circuit, and CLEARLY STATE the results of each configuration of inputs to Canvas. Remember, you can screenshot your desktop by pressing the prt scrn key if you need to. You can then paste the image into a word document or image file. (Screenshot 50 pts., Answers 10pts. each)