Use Cisco Packet Tracker to perform all the following steps

Tasks: Introduction (devices Connectivity, IP Assigning,) I have connected the devices using following ports of the switch in the figure above. Now IP assigning: Similarly, assigning the IPs of PC1 (192.168.1.2), PC2 (192.168.1.3), PC3 (192.168.1.4), PC4 (192.168.1.5), PC5 (192.168.1.6), PC6 (192.168.1.7), PC7 (192.168.1.8), PCB (192.168.1.9), PC9 (192.168.1.10), PC10 (192.168.1.11), PC11 (192.168.1.12), PC12 (192.168.1.13), PC13 (192.168.1.14), PC14 (192.168.1.15), PC15 (192.168.1.16) respectively. Now we will make different VLANs: For Switch0; First, naming the VLANs Then, allotting the fastEthernet ports to different VLANs Allotting port 0/1 and 0/2 to VLAN 4 that is bscs4a. Allotting port 0/3 and 0/4 to VLAN 5 that is bscs4b. Allotting port 0/5 and 0/6 to VLAN 6 that is bscs4c. Allotting port 0/7 and 0/8 to VLAN 7 that is bscs4d. Now using the command "show ylan", to display the VLANs I Repeat the above steps for Switch1. Packet Simulation(Same VLAN and Different Switches) Packet simulation on same VLAN but different switches, PC2 and PC10 both belongs to VLAN 5. Connection Testing Between same VLAN on Same Switch Testing the connection within same VLAN and same switch PCO and PC1 both belongs to VLAN 4. Connection Testing Between Different Switches To test the connection between different switches, first we need to give command (switchport mode trunk) on the port that is connecting the both switches. Testing the connection with same VLAN, but different switches PC1 and PC8 both belongs to VLAN 4.