Use the above interface to configure IPv$4$ for PC$1$ the same way you do in Packet Trcaer Any area that does not need a configuration must be filled with N $/$ AYou have turn R$1$ which is a brand new router to start configuring it$.$ Following is displayed. Which option will take you to User EXEC Mode? Fill in the blank. cisco Systems, Inc. $170$ West Tasman Drive San Jose, California $95134-1706$ Cisco IOS Software, $2800$ Software $($C$2800$NM$-$ADVIPSERVICESK$9-$M$),$ Version $12\mathrm{.}4(15)$T$1,$ RELEASE SOFTWARE $($fc$2)$ ########################################################## $-$ System Configuration Dialog $-$ Continue with configuration dialog? $[$yes$/$no$]$:Use Cisco $2811$ Router and $2960$ Switches to create the internetwork shown in Topology Diagram in Packet Tracer. Topology Diagram Addressing Table Use Following Network Addresses $192\mathrm{.}168\mathrm{.}1\mathrm{.}0/24$ for the LAN attached to Fa O$/0$ of R$1192\mathrm{.}168\mathrm{.}2\mathrm{.}0/24$ for the LAN attached to FaO $/1$ of R $1$ Task $1$ Use the information provided in Addressing Table, and under Use Following Network Addresses to configure IP addresses of the internetwork of Topology Diagram in Packet Tracer. Move to next question to start answering them. The information in this Instructions segment is needed to answer all questions. Important Note All fill in blank questions must be typed in lowercase $($except when typing the name of devices such as R$1$ and S$1,$ and S$2).$ Type complete commands in fill in blank questions and avoid abbreviations.You booted R$1($your brand new router$)$ and accessed User EXEC Mode and following prompt is displayed: Router: Now you need to change the router's name to R$1.$ You know the first step is to go to Privilege EXEC Mode. Complete the step by filling the blank: Router: Use lowercase and complete command Question $4$ Your router displays following prompt: Router# What command will take you to Router$($Config$)$# prompt? Router# Use lowercase and complete command Question $5$ Your brand new router displays following prompt: Router$($config$)$ H What command will change the router's name to R$1?$ Fill in the blank: Router$($config$)$#