USING CCS PROGRAMMING ONLY

Write a program to do the following Blink LEDs at the rate of 2Hz Enable UART to accept user command and display messages. Configure the pin P6.1 as analog input and sample with ADC. Use the function ADC14_setResolution to set ADC resolution to 12 bit. o Enable Timer A to interrupt at the rate of SAMPLE_FREQ=16000 Use SMCLK clock source for Timer Interface and configure to output through SPI DAC chip MCP4921 as in Problem 1. On ADC14 interrupt, sample data from the pin P6.1, then output the same data to DAC. Build and run your program on LauchPad. Write a program to do the following Blink LEDs at the rate of 2Hz Enable UART to accept user command and display messages. Configure the pin P6.1 as analog input and sample with ADC. Use the function ADC14_setResolution to set ADC resolution to 12 bit. o Enable Timer A to interrupt at the rate of SAMPLE_FREQ=16000 Use SMCLK clock source for Timer Interface and configure to output through SPI DAC chip MCP4921 as in Problem 1. On ADC14 interrupt, sample data from the pin P6.1, then output the same data to DAC. Build and run your program on LauchPad