Using the table, you made in Task 1 , assign subnets addresses to the topology. Note: Make sure to document the assignment of the IP addresses in a separate file to keep track of them. 1 Assign the first usable IP address and appropriate subnet mask of subnet 1 to the R3 interface connected to the Office3 network. 2 Assign the first usable IP address and appropriate subnet mask of subnet 2 Y to the R3 interface connected to the Office 2 network. 3 Assign the first and second usable IP address and appropriate subnet mask of subnet 3 to the R1R2 WAN link. 4 Assign the first and second usable IP address and appropriate subnet mask of subnet 4 to the R1R3 WAN link. 5 Assign the first and second usable IP address and appropriate subnet mask of subnet 5 to the R2 R3 WAN link. 6 Assign the last usable addresses of subnet 6 to the Office1 network CEO end devices. Also, assign a subnet mask and the default gateway (first address in the subnet). Note: Layer 3 connectivity with VLANs requires a router-on-a-stick setup. 7 Assign the last usable addresses of subnet 7 to the Office1 network Copyrighter end devices. Also, assign a subnet mask and the default gateway (first address in the subnet). 8 Assign the last usable addresses of subnet 8 to the Office1 network Dialer end devices. Also, assign a subnet mask and the default gateway (first address in the subnet). 9 Assign the last useable IP addresses of subnet 2 (Office2) and subnet 1 (Office3) to the endpoints for each office network or VLAN. Also, assign the default gateway (first address in the subnet)