Will rate answer.

Question 1 (25 pts): The following table was shown on the short answer portion of Exam 1. This table describes the input electrical characteristics of an oscilloscope measurement system using a 1x/10x passive probe. Model the system impedance for the 1x mode configuration as a parallel RC circuit whose resistance and capacitance values are specified by the input resistance and capacitance values in the table below. Bandwidth DC to 200 m2 1.5 m DC 16M 1.5m Probe length Attentuation ratio Compensation range All oscilloscopes with 1 MOInput P2220 15 to 25 pF P2221 10 to 25 pF 17.0 pF 110 pF Input capacitance Input resistance 10 MO 1 MO a) Specify the input impedance of the system at 10 MHz (5 pts) b) Specify the input impedance of the system at 10 kHz. (5 pts) c) Assume that this system is used to directly measure the output of a function generator with standard 5012 output impedance which is configured to generate a sinusoid with 1 Vpp amplitude. Compute Vpp that would be measured on the oscilloscope if the generator frequency was set to 10 MHz (5 pts) and 10 kHz. (5 pts) d) Write a sentence specifying why your results in 1c) violates the idea of an ideal voltage measurement device (5 pts). Question 1 (25 pts): The following table was shown on the short answer portion of Exam 1. This table describes the input electrical characteristics of an oscilloscope measurement system using a 1x/10x passive probe. Model the system impedance for the 1x mode configuration as a parallel RC circuit whose resistance and capacitance values are specified by the input resistance and capacitance values in the table below. Bandwidth DC to 200 m2 1.5 m DC 16M 1.5m Probe length Attentuation ratio Compensation range All oscilloscopes with 1 MOInput P2220 15 to 25 pF P2221 10 to 25 pF 17.0 pF 110 pF Input capacitance Input resistance 10 MO 1 MO a) Specify the input impedance of the system at 10 MHz (5 pts) b) Specify the input impedance of the system at 10 kHz. (5 pts) c) Assume that this system is used to directly measure the output of a function generator with standard 5012 output impedance which is configured to generate a sinusoid with 1 Vpp amplitude. Compute Vpp that would be measured on the oscilloscope if the generator frequency was set to 10 MHz (5 pts) and 10 kHz. (5 pts) d) Write a sentence specifying why your results in 1c) violates the idea of an ideal voltage measurement device (5 pts)