Answered step by step
Verified Expert Solution
Question
1 Approved Answer
With the strain gauge set shown in the attached picture, E = 290 , B = -180 and = &c = -600 have been
With the strain gauge set shown in the attached picture, E = 290 , B = -180 and = &c = -600 have been measured from the surface of the steel piece in the of resistance. It is assumed that the load that produced the strains does not occur on the surface to which the strain strips are glued. In addition, it is known that the material the yield strength is R = 235 MPa, elastic modulus E = 195 GPa and Poisson's constant = 0.26 and the material is isotropic. Specify a) the component matrix of the strain tensor of the small strains of the deformation at the measurement point, [] = b) stress component matrix in the image coordinate system, [0] = u and Overt = c) Determine the reference stress according to the von Mises yield condition at the measurement point, MPa and MPa. nVvEH = d) certainty of the measurement point according to the sales ratio von Mises, 2 45 B A X1
Step by Step Solution
★★★★★
3.26 Rating (170 Votes )
There are 3 Steps involved in it
Step: 1
SOLUTION To solve this problem well break it down into several steps a Component Matrix of the Strai...Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started