Write a Java code To create a smart home system for collecting two sensor data from a thermometer and a hygrometer. Both sensor data should continuously show on a monitor. The data collecting frequency for the thermometer is about 1 second, and the frequency for the hygrometer is about 2 seconds. In addition, the data range for a thermometer is between 0 to 45 degrees, and the data range for a hygrometer is between 0 to 100%. Both sensors should run forever unless the user shuts down the system. It should implement this system according to the design below: Please check below for a sample output when the system is activated. You must follow the system design and have the same printing format in order to receive full marks. [Thermometer]:5 degree [Hygrometer]:84% [Thermometer]:9 degree [Thermometer]:21 degree [Hygrometer]:57% [Thermometer]:15 degree [Thermometer]:14 degree [Hygrometer]:96% [Thermometer]:29 degree [Thermometer]:6 degree [Hygrometer]:22% [Thermometer]:0 degree [Thermometer]:17 degree [Hygrometer]:4% [Thermometer]:33 degree [Thermometer]:10 degree [Hygrometer]:59% [Thermometer]:8 degree [Thermometer]:12 degree [Hygrometer]:75% [Thermometer]:18 degree [Thermometer]:11 degree [Hygrometer]:49% [Thermometer]:27 degree [Thermometer]:18 degree [Hygrometer]:76% [Thermometer]:22 degree [Thermometer]:44 degree [Hygrometer]:73% [Thermometer]:36 degree