Write the Lab report for following experiment and answer all the questions. COMPONENTS Jumper Wire pieces 1 LED (optional) Arduino Uno Board USB Cable (Type B) Breadboard toggle switch Pushbutton, wire switch Rout 300 ohm Rin 1k-4k ohm PROCEDURE 1. Type program1.c into Arduino IDE and flash your development board. 2. Connect the illustrated circuit. Test circuit and monitor serial data on host PC 3. Replace pushbutton with toggle switch. Test circuit and monitor serial data on host PC. 4. Replace toggle switch with two wires. Test circuit and monitor serial data on host PC. Make connection between the two wires and release to simulate on and off state of the switch. 5. Repeat steps 2 through 4 after removing the resistor from pin 2 going to ground (keep notes). 6. Reconnect Rin. Type program2.c, flash device and repeat steps 2 through 4 Write the Lab report for following experiment and answer all the questions. COMPONENTS Jumper Wire pieces 1 LED (optional) Arduino Uno Board USB Cable (Type B) Breadboard toggle switch Pushbutton, wire switch Rout 300 ohm Rin 1k-4k ohm PROCEDURE 1. Type program1.c into Arduino IDE and flash your development board. 2. Connect the illustrated circuit. Test circuit and monitor serial data on host PC 3. Replace pushbutton with toggle switch. Test circuit and monitor serial data on host PC. 4. Replace toggle switch with two wires. Test circuit and monitor serial data on host PC. Make connection between the two wires and release to simulate on and off state of the switch. 5. Repeat steps 2 through 4 after removing the resistor from pin 2 going to ground (keep notes). 6. Reconnect Rin. Type program2.c, flash device and repeat steps 2 through 4