You are requested to configure the following devices: ASBR 1, ABR 2, ABR 3, Router 1, Router 2, LIU, SWA, SWB, PCO and PCl. Static Routing 1. Configure a default static route on ASBR I Router. Multi-Area OSPF 1. Configure Multi-Area OSPF with process ID 1 on ASBR 1,ABR2,ABR3, Router 1 , Router 2. Advertise the routes that belongs to the OSPF domain ONLY. 2. Propagate the Default Route on the OSPF routers. 3. Set Serial 0/0/1 as Passive Interfaces on ASBR 1 router. 4. Set the hello and dead intervals respectively to 5 and 10 on ASBRI, ABR2 and ABR3 Gigabitethernet 0/0 interfaces. 5. Set the OSPF priority on ABR2 Gigabitethernet 0/0 to 200. EIGRP 1. Configure EIGRP routes with AS1 on ABR3 and LIU and advertise the routes that belongs to EIGRP Domain ONLY. 2. Set G//0 as Passive Interface on LIU through the EIGRP process. HSRP 1. Configure Router 1 to be the Active Router on GigaEthernet 0/0 (Group Number 1) a. Set Standby version 2 b. Set the virtual IP address to be 192.168.2.254 c. Set the priority number to be 150 d. Enable Preemption 2. Configure Router 2 to be the Standby Router on GigaEthernet 0/0 (Group Number 1) a. Set Standby version 2 b. Set the virtual IP address to be 192.168.2.254 EtherChannel 1. Create a channel group 1 on SWA and SWB on GigaEthernet 0/1 and 0/2. (Use mode on) 2. Set Port Channel 1 as Trunk port on SW1 and SW2. 3. Set the native VLAN on Port Channel 1 to be 10. PC configuration 1. Assign the IP address, subnet mask, gateway address and the DNS address 64.100.1.2 to PC0 and PCl