Question: Your network has two distribution layer switches (SwitchA and SwitchB) connected through trunk ports on each of their respective Gi 0/1 interfaces. In addition,
Your network has two distribution layer switches (SwitchA and SwitchB) connected through trunk ports on each of their respective Gi 0/1 interfaces. In addition, you recently connected an access layer switch to the network, SwitchC. SwitchC has several workstations and a server belonging to VLAN 20. Because the resources on VLAN 20 are exclusive to the local workstations, you need to restrict VLAN 20's traffic from passing though the network on the SwitchC trunk ports. In this lab, your task is to: . Remove only VLAN 20 from the allowed VLANs on SwitchC's GigabitEthernet 0/1 and GigabitEthernet 0/2 interfaces. Save your changes to the startup- config file. SwitchA GIO/1 G0/2 GO/1 SwitchC Gi0/1 Gi0/2 Gi0/2 SwitchB
Step by Step Solution
3.46 Rating (146 Votes )
There are 3 Steps involved in it
Here are the steps involved Connect to SwitchC using Telnet or SSH Enter the following command to enter global configuration mode configure terminal E... View full answer
Get step-by-step solutions from verified subject matter experts
