1. Write a program to model a simple calculator. Each data line should consist of the next operation to be performed from the list below and the right operand. Assume the left operand is the accumulator value initial value of 0). You need a function scan_data with two output parameters that returns the operator and right operand scanned from a data line. You need a function do_next_op that performs the required operation. do_next_op has two input parameters (the operator and operand) and one input/output parameter (the accumulator). The valid operators are: + add - subtract * multiply / divide ^ power (raise left operand to power of right operand) q quit Your calculator should display the accumulator value after each operation. A sample run follows. + 5.0 result so far is 5.0 ^2 result so far is 25.0 / 2.0 result so far is 12.5 00 final result is 12.5 1. Write a program to model a simple calculator. Each data line should consist of the next operation to be performed from the list below and the right operand. Assume the left operand is the accumulator value initial value of 0). You need a function scan_data with two output parameters that returns the operator and right operand scanned from a data line. You need a function do_next_op that performs the required operation. do_next_op has two input parameters (the operator and operand) and one input/output parameter (the accumulator). The valid operators are: + add - subtract * multiply / divide ^ power (raise left operand to power of right operand) q quit Your calculator should display the accumulator value after each operation. A sample run follows. + 5.0 result so far is 5.0 ^2 result so far is 25.0 / 2.0 result so far is 12.5 00 final result is 12.5