937. Multiple Choice Questions Select the best answer for each of the following questions. Explain the reasons for your selection. a. Which of the following is an element of sampling risk? (1) Choosing an audit procedure that is inconsistent with the audit objective. (2) Concluding that no material misstatement exists in a materially misstated population based on taking a sample that includes no misstatement. (3) Failing to detect an error on a document that has been inspected by an auditor. (4) Failing to perform audit procedures that are required by the sampling plan. b. In assessing sampling risk, the risk of incorrect rejection and the risk of assessing control risk too high relate to the: (1) Effi ciency of the audit. (2) Effectiveness of the audit. (3) Selection of the sample. (4) Audit quality controls. c. Which of the following statistical sampling techniques is least desirable for use by the auditors? (1) Random number table selection. (2) Block selection. (3) Systematic selection. (4) Random number generator selection. d. The auditors primary objective in selecting a sample of items from an audit population is to obtain: (1) A random sample. (2) A stratifi ed sample. (3) A representative sample. (4) A large sample. e. Discovery sampling is particularly effective when: (1) There are a large number of errors in the population. (2) The auditors are looking for critical deviations that are not expected to be frequent in number. (3) The auditors know where deviations are likely to occur. (4) The population is large in size. f. The auditors are using unstratifi ed mean-per-unit sampling to audit accounts receivable as they did in the prior year. Which of the following changes in characteristics or specifi cations would result in a larger required sample size this year than that required in the prior year? (1) Larger variance in the dollar value of accounts. (2) Smaller population size. (3) Larger tolerable misstatement. (4) Higher risk of incorrect acceptance.

g. Which of the following sampling techniques is typically used for tests of controls? (1) Mean-per-unit sampling. (2) Difference sampling. (3) Attribute sampling. (4) Probability-proportional-to-size sampling. h. Which of the following is accurate regarding tolerable misstatement? (1) Tolerable misstatement is directly related to materiality. (2) Tolerable misstatement cannot be determined until the sample results are evaluated. (3) Tolerable misstatement does not affect sample size. (4) Tolerable misstatement is a measure of reliability of the sample. i. In which of the following circumstances is it least likely that tests of controls will be performed? (1) The expected deviation rate exceeds the tolerable deviation rate. (2) The planned assessed level of control risk is at a level slightly below the maximum. (3) The risk of assessing control risk too low is less than the expected deviation rate. (4) The tolerable deviation rate exceeds the risk of assessing control risk too low. j. An auditor needs to estimate the average highway weight of tractor-trailer trucks using a states highway system. Which estimation method is most appropriate? (1) Mean per unit. (2) Difference. (3) Ratio. (4) Probability proportional to size. k. The auditors have sampled 50 accounts from a population of 1,000 accounts receivable. The sample items have a mean book value of $200 and a mean audited value of $203. The book value in the population is $198,000. What is the estimated audited value of the population using the mean-per-unit method? (1) $198,000. (2) $200,000. (3) $201,000. (4) $203,000. l. Using the same facts as in (k) above, what is the estimated total audited value of the population using the difference method? (1) $198,000. (2) $200,000. (3) $201,000. (4) $203,000.