A 150.00 mm sine bar is used to inspect a part angle that has a dimension of 35.0° ± 1.0°. The sine bar rolls have a diameter = 25.0 mm. A set of gage blocks is available that can form any height from 10.0000 mm to 199.995 mm in increments of 0.005 mm. All inspection is performed on a surface plate. 

Determine

(a) the height of the gage block stack to inspect the minimum angle, 

(b) the height of the gage block stack to inspect the maximum angle, 

(c) the smallest increment of angle that can be set up at the nominal angle size.