can any one help on this PLC program

Implement following problem in LogixPro environment.

Using sequencer output instruction, develop a program to implement an automatic car wash process. The process is to be event driven by the vehicle, which sequentially activates various limit switches (LS1 through LS6) as it is pulled by a conveyor chain through the car wash bay. Design the program to operate the car wash in the following manner.

• The vehicle is connected to conveyor chain and pulled inside the car-was bay.
• LS1 turns the water input valve ON
• LS2 turns the soap release valve, which mixes with the water input valve to provide a wash spray
• LS3 shuts off the shop valve, and water input valve remains ON to rinse the vehicle
• LS4 shuts OFF the water input valve and activates the hot wax valve, if selected
• LS5 shuts OFF the hot wax valve and starts the air blower motor
• LS6 shuts OFF the air blower. The vehicle exits the car wash.

Use I/O simulator screen and the following addresses to simulate the program.

• LS1 I:1/1
• LS2 I:1/2
• LS3 I:1/3
• LS4 I:1/4
• LS5 I:1/5
• LS6 I:1/6
• Hot wax switch I:1/7
• Water input valve O:2/1
• Soap input valve O:2/2
• Hot wax valve O:2/3
• Air blower Motor O:2/4