CCS C is the required language, to be done with 1 or 2 D arrays, please.

4. The photo below shows an electric device called a transformer". Transformers are often constructed by wrapping coils of wire around a ferrite core. The figure illustrates a situation that occurs in various audio devices such as cell phones and music players. In this circuit, a transformer is used to connect a speaker to the output of an audio amplifier Ra = 20 2 V = 40 V R,=822 Amplifier Transformer Speaker The symbol used to represent the transformer is intended to suggest two coils of wire. The parameter n of the transformer is called the "turns ratio" of the transformer. (The number of times that a wire is wrapped around the core to form a coil is called the number of turns in the coil. The turns ratio is literally the ratio of the number of turns in the two coils of wire. When designing the circuit, we are concerned primarily with the value of the power delivered to the speakersthat power causes the speakers to produce the sounds we want to hear. Suppose we were to connect the speakers directly to the amplifier without using the transformer. Some fraction of the power available from the amplifier would get to the speakers. The rest of the available power would be lost in the amplifier itself. The transformer is added to the circuit to increase the fraction of the amplifier power that is delivered to the speakers. The power, Ps, delivered to the speakers is calculated using the formula nV Pg=R nR + R, Write a program that models the circuit shown and varies the turns ratio from 0.01 to 2 in 0.01 increments, then determines the value of the turns ratio that maximizes the power delivered to the speakers