Question
Configure the given network using OSPF and as per the areas shown in the topology. All the IP addresses used in routers should be from
Configure the given network using OSPF and as per the areas shown in the topology.
All the IP addresses used in routers should be from 192.168.1.0/24
How can I achieve this?
I can set the IP addresses in the range. I can set the fa 0/0 in R1 as 192.168.1.1/24, the fa 0/0 in R3 as 192.168.1.2/24, but I failed to set the fa 1/0 in R3 as 192.168.1.3/24, it says 192.168.1.0 overlaps with fa 0/0.
How to solve this problem?
A1 fa1/0 R3 fa0/0 fa0/0 R1 fa3/0 (fa1/0 R5 (fa2/0 AO fa3/0 A2 fa2/0 R4 (fa0/0 fa0/0 R2 fa4/0) A3 fa4/0 R6
Step by Step Solution
3.39 Rating (146 Votes )
There are 3 Steps involved in it
Step: 1
The given network topology has been created using cisco packet tracer For this configuration Router model 2911 has been used and serial ports are adde...Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started