Form a project to configure SPI$4$ and SPI$5$ modules as master and slave, respectively in non$-$

blocking mode. There should be two counter values in your code. The first one will be sent to the

slave from master. Upon receiving this data by the slave, the green LED connected to pin PG$13$ of

the STM$32$F$4$ board will toggle if mod $3$ of the received counter value is equal to zero. Afterward,

the second counter will be sent to master from slave. Upon receiving this data by the master, the

red LED connected to pin PG$14$ of the STM$32$F$4$ board will toggle if mod $5$ of the received counter

value is equal to zero. This operation will be repeated every $2$ seconds. When the transmission and

reception is complete, the LEDs are toggled in callback functions. The pin PA$0,$ in which the push

button on the STM$32$F$4$ board is connected to$,$ is configured in interrupt mode. Form the project

using C language. $[20$ pt$]$