Host A Host B VLAN 1 8w1t show running-oontig output omieced> interface g0/1 switchport mode dynamice auto switchport trunk encapaulation dotlq awitehport trunk native vian 666 Host C Host D VLAN 10 abow running-config Coutput omitted> interface go/i switchport mode dynamic auto swite switehport trunk native vlan 666 SW1 trunk SW2 hport trunk encapsulation dotlg VLAN 30 Host E Host F fer to the exhibit. The network administrator configures both switches as displayed. However, hs C is unable to ping host D and host E is unable to ping host F. What action should the administrator take to enable this communication? A) Include a router in the topology B) Associate hosts A and B with VLAN 10 instead of VLAN 1. C) Remove the native VLAN from the trunk. Configure either trunk port in the dynamic desirable mode D) E) Add the switchport nonegotiate command to the configuration of SW2 What is a characteristic of spanning tree? A) It is enabled by default on Cisco switches. B) 6. It has a TTL mechanism that works at Layer 2 It prevents propagation of Layer 2 broadcast frames C) D) It is used to discover information about an adjacent Cisco device. A set of switches is being connected in a LAN topology. Which STP bridge priority value will make it least likely for the switch to be selected as the root? A) 4096 B) 32768 C) 61440 D) 65535 7. 8