I need the commands, please. Using cisco packet tracer

Task 1: Prepare the Network - Using PacketTracer to create the topology and cable your network as shown in the image. - Make sure your Routers have enough Interfaces - Use 2911's Task 2: Determine IP Addressing Scheme - Using the provided table above and create a IP scheme. - You can create your own IP scheme based off what you would like to use for IP Addressing. Task 3: Perform Basic Router Configuration - Configure the interfaces on R1, R2, and R3. Task 4: Configure a routing protocol - Configure a routing protocol on all the routers - Make sure to include the networks that the PC's reside on. Task 5: - Enable SSH on Routers - Use ics for username and password. Task 6: Configure switches, Server \& PCs - Give PCs and Server IP Addresses, make sure they can ping across the network - Enable Web and FTP on the server Task 7: ACLs - Make sure the following is configured on the network: - PC1 and PC0 can talk - PC1 cannot connect to Server0 FTP - PC1 can connect to Server0 WWW - Only Hosts on PC0 network can SSH to Router 1 - Only Hosts on PC1 network can SSH to Router 0 Instructions Example Table