Answered step by step
Verified Expert Solution
Question
1 Approved Answer
In this assignment, you will create and configure a network using the Packet Tracer network simulator. You will implement VLAN, INTER - VLAN routing, and
In this assignment, you will create and configure a network using the Packet Tracer network
simulator. You will implement VLAN, INTERVLAN routing, and Static Route, and verify proper
operation of the network from end to end.
Part : points
Create the following topology in Packet Tracer. Use the device models as shown.
If you are not able to use these models, then pick and choose models of your
own choice.
Display interface labels. All labels should be clearly visible.
Copy the diagram to your report MS Word Use Snipping Tool to copy and paste
all required outputs
Add an appropriate title
XYZ Corporation Network Topology:
Part : points
Using the specs in Table below configure Router & Switch Switch and PCs to
VLANs should be named as given. The frame tagging protocol to be used is
IEEEQ
Configure Static route on Router &
From PC ping PC PC and PC points
Ensure pings are successful. If not, troubleshoot and fix the problem.
Copy ping commands together with the results to the report on to a separate page
with an appropriate title.
For PCs to select the Config tab and the Interface F and copy a screenshot showing
the MAC and IP address of each PC on to a separate page with appropriate titles.
Copy routing table of Routers on to a separate page with appropriate title. points
TABLE Device Configuration Specification:
Routers Switches PCs
Part : points
Using the specs in Table above configure Switch and PCs and
From PC ping PC and PC points
Ensure pings are successful. If not, troubleshoot and fix the problem.
Copy ping commands together with the results to the report on to a separate page
with an appropriate title.
Copy VLAN database of switch on to a separate page with appropriate title.
Provide VLAN Brief of Switches S and S on to a separate page with appropriate title.
points
REPORT FORMAT:
Submit a Word document with page numbering at the bottom of page and with the following
information in the given order:
A cover page with name of assignment, date of submission.
A screenshot of the topology with the required information on a separate page.
The required outputs from the subsequent steps on separate pages with
appropriate titles as specified.
No extraneous information should be included in the report.
CHECK LIST: Ensure that the pages are in the correct order under each part as given in Report
Format, the information is clear, uncluttered, and presented in the manner requested. Points
will be deducted if the report does not strictly conform to the above format or is incomplete.
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started