Mark this question for review A workstation is connected to a switch on the Gi 0/2 interface using a straight-through cable. The Ethernet interface in the workstation has been manually configured to use a 100 Mbps link speed in full-duplex mode. Which of the following are true in this scenario? (Select three.) The switch interface will display as administratively down If the link speed is 10 Mbps or 100 Mbps, half-duplex is used. If the link speed is 1000 Mbps or faster, half-duplex is used. The switch attempts to sense the link speed. Ifit can't, the slowest link speed supported on the interface is selected If the link speed is 1000 Mbps or faster, full-duplex is used. If the link speed is 10 Mbps or 100 Mbps, full-duplex is used