ons: ts or 17 30 60 Initial blank shape 30 60 30 10 Final shape 12 3. This question is about Workholding: Describe the workholding of the part below (identical to the Part in Question 2 above), for the machining of the top surface, the four slots, and the two through-holes. [S points] You must draw and label all the components of the fixture/jig you propose. You must show heights of locators where needed (though, no dimensioning is needed). You must show all the directions of clamping and machining. State all your assumptions clearly. YOU MAY USE THE FIGURE BELOW IN ORDER TO DRAW YOUR PROPOSED FIXTURE/JIG AROUND IT. WELS