PART 1: Determining the dielectric constant K for teflon 1. Click on the experiment link above. You should see the image below: 2. Click on Dielectric at the top 3. Check the box Capacitance under meters 4. Choose the Dielectric material teflon- 5. Slide the dielectric so that it fills the space between the capacitor plates with an offset of 0.00 mm. 6. Set plate separation d to 10.0 mm_(0.01 m) . Keep d constant throughout the experiment. 7. Start with a plate area A of 100 mm'. Record the Capacitance C in your data table. 8. Repeat step 7 with 8 different values of A up to 400 mm?. Note that you can change the value of A by sliding the arrow. 9. Plot a graph of C (vertical axis) vs A (horizontal axis) You should change your values of A to m' for plotting. 10. What is the slope of your graph? 11. Using the value of your slope and Equation 3, determine the dielectric constant K for tefter 12. The accepted value K for teflon is 2.1. Determine the experimental error between your determined value and the accepted value of K for teflon TABLE 1: Teflon A (mm) A (m?) C (F) 100 400