Physical x: 563,y:496 Time: 00:04:44 Packet Tracer Build two networks interconnected with cisco router 2811 First network to consist of 1 Cisco 4331 Router 1 Cisco 2960 Switch 1 End User Laptop (Employee VLAN) 1 End User PC (Guest VLAN) 2 IOT Devices Lamp and Motion Detector Second Data Center to consist of 1 Cisco 4331 Router 1 Cisco 2960 Switch 1 End User Laptop (Employee VLAN) 1 End User PC (Guest Static IP address) 1 individual HTTP Server (Server VLAN) 1 individual DNS Server (Server VLAN) 1 IOT Registration Server (Server VLAN) Cisco 2811 Router to interconnect all the locations REQUIREMENTS: - Create and deploy IP address Scheme for all devices - Each device must be labeled with its IP Address and Role. - Each PC/Laptop should have a correct IP address, Subnet Mask, DNS server and Gateway set. - Each Device must be able to PING each other across the whole network using the given IP addressing Scheme - VLANs - Each site to use 3 VLANS - You can NOT use VLAN 1 for any device. Place 1 Laptop in Employee VLAN and place the PC in the Guest VLAN at all sites, place the IOT device in the IOT VLAN. Recall, each VLAN will need its own IP address network. You will do the same for the California Data Center but will have an additional VLAN for Servers and do not need an IOT VLAN - Use Sub-Interfaces on Routers to provide routing for the VLANs. - Connect one of the Office/DC Routers ports to the Verizon Router and configure Specific Static Routes - All routers may only use Static Routing - California is the Branch Office - 3 VLANs - Employee, Guest, and IOT - Oregan is the Data Center - 3 VLANs - Employee, Guest, and Server - 1 HTTP Server with working webpage - 1 DNS Server- should be able to leverage URL name to access built in web page. Use http://youtube.com/ as the website url. - 1 10T Server - Registration Server for IOT devices - Place IOT devices at the California Branch Office