Problem 4: Natural Cubic Spline in Matlab The goal of this problem is to draw Mount Everest with the help of natural cubic splines. We have a rather poor quality photo of the mountain profile, which is given below. You need to set up a coordinate system, and select a set of knots along the edge of the mountain, and find the coordinates for all these interpolating points. We are aware that the mountain profiles are not very clear in that photo, so please use your imagination when you find these approximate points. You may either print out the mountain picture and work on it on a piece of paper, or send the image to some software and locate the coordinates of the interpolating points. Make sure to select at least 20 points. You may use more points if you see fit. After you have generated your data set, you need to find a natural cubic spline interpolation. Use the functions cspline and cspline_eval, which are available in Section 3.4. Read these two functions carefully, try to understand them before using them Does it look like there is a smaller peak on the right? Does the peak look rather sharp? How would you deal with this situation, knowing that a single cubic spline function will generate a "smoothest" possible interpolation? What you need to hand in: A Matlab script that contains your data set, compute the spline functions, and draw the mountain. Also the plot of your Mount Everest. Have Fun! Fig. 3.3 Natural cubic spline, for Mount Everest