Show the required MINITAB output with the steps to find the MINITAB output

8.37. An article in Soldering \& Surface Mount Technology ("Characterization of a Solder Paste Printing Process and Its Optimization," 1999, Vol. 11, No. 3 , pp. 23-26) describes the use of a 283 fractional factorial experiment to study the effect of eight factors on two responses; percentage volume matching (PVM) - the ratio of the actual printed solder paste volume to the designed volume; and non-conformities per unit (NPU) - the num- an industry workmanship standard. The factor levels are ber of solder paste printing defects determined by visual shown below and the test matrix and response data are inspection (20' magnification) after printing according to shown in Table P8.9. 384 Chapter 8 - Two-Lewe Fractional Factorial Dedigns (a) Verify that the generators are I=ABCF,I=ABDG, and I=BCDEH for this design. (b) What are the aliases for the main effects and twofactor interactions? You can ignore all interactions of order three and higher. (c) Analyze both the PVM and NPU responses. (d) Analyze the residual for both responses. Are there any problems with model adequacy? (e) The ideal value of PVM is unity and the NPU response should be as small as possible. Recommend suitable operating conditions for the process based on the experimental results