Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Sometimes during the manufacturing of an integrated circuit, wires-including control signal wires-are accidentally connected to +V or GND, resulting in a control signal that is
Sometimes during the manufacturing of an integrated circuit, wires-including control signal wires-are accidentally connected to +V or GND, resulting in a control signal that is stuck-at-1 (when connected to +V) or stuck-at-0 (when connected to GND). This is a hardware bug which will manifest itself when certain assembly language instructions are executed and do not perform the operation they are supposed to perform. Suppose the RegDst signal is stuck at 0. For each of the instructions that are implemented in the single-cycle design (using the datapath shown on p. 17 of the Ch. 4 lecture notes), list the instruction and explain if the instruction will or will not properly execute. If the instruction is affected by the hardware bug, then instead of what should happen, explain what will actually happen. Repeat exercise (a) assuming that RegDst is instead stuck at 1. Repeat exercise (a) assuming that MemToReg is stuck at 0. Repeat exercise (a) assuming that MemToReg is stuck at 1
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started