"That old equipment for producing oil drums is worn out," said Bill Seebach, president of Hondrich Company. "We need to make a decision quickly." The company is trying to decide whether it should rent new equipment and continue to make its oil drums internally or whether it should discontinue production and purchase them from an outside supplier. The alternatives follow. Aftemative f Rent new equipment for producing the oil drums for $175.000 per year. Attemative 2. Purchase oil drums from an outside supplier for $17.80 each. Hondrich Company's costs per unit of producing the oil drums internally (with the old equipment) are given below. These costs are based on a current activity level of 35,000 units per year: The new equipment would be more efficient and, according to the manufocturer, would reduce direct labour costs and variable overhead costs by 25\%. Supervision cost (\$87,500 per year) and direct materiais cost per unit would not be affected by the new equipment. The new equipment's capacity would be 62.500 oll drums per yeat. The total general company overhead would be unaffected by this decision. 2. Seebach is unsure what the company should do and would like an analysis showing the unit costs and total costs for each of the two alternatives given above. 0-1. What will be the total reievant cost of 50,000 subassemblies if they are manufactured internally? 0.2. What would be the per unit cost of subassembly manufactured internally? (Do not round intermediote calculations. Round your answer to 2 decimal ploces.) 0.3. Which course of action would you recommend if 50,000 assemblies are needed each year? Indifferent between the two alternatives Purchase from the outside supplier Manufacture internally b-1. What will be the total relevant cost of 62,500 subassemblies if they are manufactured internally? b.2. What would be the per unit cost of subassembly manufactured internally? (Do not round intermediate calculations. Round your answer to 2 decimal pleces.) b.3. Which course of action would you recommend if 62,500 assemblies are needed each year? Purchase from the outside supplier Indifferent between the two alternatives Manufacture internally