The authoritative source on grounding requirements for a PLC installation is the (Spts) A. plant electrician. B. plant engineer equipment manufacturer D. National Implement a bearing lubrication PLC program. The VO list has been provided below 15. (15 pts) Input/Output I:1/0 Switch sh Button MI Motor Pilot Lamp TON O:2/0 0:2/1 O:2/2 T4:0 T4:1 TOF RTO T4:2 1. To start the machine, the operator turns the "Switch" on. 2. Before the motor shaft starts to turn, the bearings are supplied with oil by the pump for 20 seconds. 3. When the operator turns the "Switch" off to stop the machine, the oil pump continues to supply oil for 30 seconds. 4. A retentive time is used to track the total running time of the pump. When the total running time is 4 hours, the motor is shut down and a pilot light is turned "on" to indicate that the filter and oil needs to be changed. 5. A reset button is provided to reset the process after the filter and oil have been changed. raw the ladder logic program for the scenario below. Be clear on the address, needed ormation, and description for each instruction