The instructions are below, please read thoroughly

I'm only have problems with filling the array appropriately, I believe there is a bug in getString macro or readVal procedure

Any help would be appreciated

Objectives: 1) Designing, implementing, and calling low-level I/O procedures

2) Implementing and using a macro Problem Definition:

Implement and test your own ReadVal and WriteVal procedures for unsigned integers.

Implement macros getString and displayString. The macros may use Irvines ReadString to get input from the user, and WriteString to display output.

getString should display a prompt, then get the users keyboard input into a memory location

displayString should print the string which is stored in a specified memory location.

readVal should invoke the getString macro to get the users string of digits. It should then convert the digit string to numeric, while validating the users input.

writeVal should convert a numeric value to a string of digits, and invoke the displayString macro to produce the output.

Write a small test program that gets 10 valid integers from the user and stores the numeric values in an array. The program then displays the integers, their sum, and their average. Requirements:

1) Users numeric input must be validated the hard way: Read the user's input as a string, and convert the string to numeric form. If the user enters non-digits or the number is too large for 32-bit registers, an error message should be displayed and the number should be discarded.

2) Conversion routines must appropriately use the lodsb and/or stosb operators.

3) All procedure parameters must be passed on the system stack.

4) Addresses of prompts, identifying strings, and other memory locations should be passed by address to the macros.

5) Used registers must be saved and restored by the called procedures and macros.

6) The stack must be cleaned up by the called procedure.

7) The usual requirements regarding documentation, readability, user-friendliness, etc., apply.

Notes: 1) For this assignment you are allowed to assume that the total sum of the numbers will fit inside a 32 bit register. 2) When displaying the average, you may round down to the nearest integer. For example if the sum of the 10 numbers is 3568 you may display the average as 356.