use logisim cting to the tunnel labeled Q. What is the second number (to the right of the slash)?

Question 2 4 pts Now use the following as a starting point of another part of this "main" circuit: kO Note the direction (facing) of the tunnels can be changed like most components. Also note the size of the gates and the number of inputs of the gates. The gates next to the tunnels on the right hand side may not be correct. Your first job is to move the gates or tunnels to the right so that the correct gate lines up with the correct tunnel. If you don't know which gate is which gate, look up the "Gates Library" part of the library reference of Logisim. Connect the tunnels from the left to inputs of the gates. If a particular tunnel is not used as input, leave it alone. Connect the output of each gate to the appropriate tunnel to the right. P, G and Q correspond to the constructs of the same name (but in lower case) in the binary adding notes When this is done, use the poking tool to specify 100 to input pin X, 010 to input pin Y, kO is not used, so it can be anything. Now use the poke tool to click the wire connecting to the tunnel labeled Q. What is the second number (to the right of the slash)? Question 2 4 pts Now use the following as a starting point of another part of this "main" circuit: kO Note the direction (facing) of the tunnels can be changed like most components. Also note the size of the gates and the number of inputs of the gates. The gates next to the tunnels on the right hand side may not be correct. Your first job is to move the gates or tunnels to the right so that the correct gate lines up with the correct tunnel. If you don't know which gate is which gate, look up the "Gates Library" part of the library reference of Logisim. Connect the tunnels from the left to inputs of the gates. If a particular tunnel is not used as input, leave it alone. Connect the output of each gate to the appropriate tunnel to the right. P, G and Q correspond to the constructs of the same name (but in lower case) in the binary adding notes When this is done, use the poking tool to specify 100 to input pin X, 010 to input pin Y, kO is not used, so it can be anything. Now use the poke tool to click the wire connecting to the tunnel labeled Q. What is the second number (to the right of the slash)