What methods can you use to review an existing network design? 17.List five (5) elements needed to meet the technical requirements of a network. 18.Explain each of the following terms in 40-90 words for each. Network segmentation Network Traffic management What basics utilities are used to confirm network operations?

19A) List the four (4) tasks included in initial switch configurations. B) Write the basic steps to perform the initial configurations.

20. List five (5) different types of each network component.

Physical Media used for transmission Network connectors

21. Explain the procedure of upgrading switch firmware through CLI

22. List five (5) various methods used to back up configuration files of network switch?

23. How can you configure trunk between two (2) switches? Provide an example to support your answer.

24. How can you create and verify the inter-Vlan route? Write the steps and commands required to complete this.

25. What steps do you need to follow to configure Rapid Spanning Tree Protocol on a network switch?

26. List the WHS/OHS Act, Regulation, Code and Regulator enforced in each state and territory of Australia.

27. List eight (8) basic utilities used to check network connectivity.

28.List ten (10) types of networks that are commonly used. Explain each network. Define Virtual Local area network (VLANs)?

29.List eight (8) devices used to create different types of networks.