Write a code called proj1.cpp in C++

The file proj1.cpp should contain the main function, int main(). In the main() function, the program should read the input until it reaches the end, counting the number of times each word, number, and character is used. A word is defined as a sequence of letters ('a'..'z' or 'A'..'Z'). Words are case insensitive ("AA", "Aa", "aA", and "aa" are the same). A number is defined as a sequence of digits ('0'..'9'). Note that both words and numbers can be of length of 1, that is, contain one letter or one digit, respectively. Different sequences represent different numbers. For example, number "001" is different from number "1". Words are separated by numbers or other non-letter and non-digit characters. Numbers are separated by words or other non-letter and non-digit characters. Your program should record the number of times each word, number, and character happens (note that characters are case sensitive). The program should then output the ten most used characters (case sensitive), the ten most used numbers, and the ten most used words (case insensitive) as well as the number of times these characters/numbers/words are used. Since words are case insensitive, the program only outputs lower case words. The characters, numbers and words should be outputted in the descending order based on the number of times they are used. When two characters happen in the same number of times, the character with a smaller ASCII value should be considered as being used more frequently. When two words (numbers) happen in the same number of times, the word (number) that occurs earlier in the input should be considered as being used more frequently.

An example executable code of the program proj1.x is provided to you. In proj1.x, the output related to the display of characters, words, and numbers is aligned in the following manner: the width of the column of the characters, words, and numbers is the length of the longest words and numbers to be displayed, plus five (5). When printing characters, use '\t' for tab and ' ' for newline. All other characters should be outputted normally.

The sample output can be downloaded in this link

http://www.cs.fsu.edu/~duan/classes/cop4530/assignments/proj1/proj1_provided.tar