Question: Determine the flooding velocity and column diameter for the following conditions at the top tray of a hydrocarbon absorber equipped with valvetrays: 400 psia Pressure

Determine the flooding velocity and column diameter for the following conditions at the top tray of a hydrocarbon absorber equipped with valvetrays:

400 psia Pressure Temperature Vapor rate Vapor MW Vapor density Liquid rate Liquid MW Liquid density Liquid surface tens

400 psia Pressure Temperature Vapor rate Vapor MW Vapor density Liquid rate Liquid MW Liquid density Liquid surface tension Foaming factor Tray spacing Fraction flooding Valve trays 128F 530 lbmol/h 26.6 1.924 lb/ft 889 lbmol/h 109 41.1 lb/ft 18.4 dynes/cm 0.75 24 in. 0.85

Step by Step Solution

★★★★★

3.35 Rating (155 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Use entrainment flooding correlation of Fig where the abscissa is For 24inch tray ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

37-E-C-E-S-P (224).docx

120 KBs Word File

Students Have Also Explored These Related Chemical Engineering Questions!

The top tray of a distillation column and the condenser arc at a pressure of 20(psia). The liquid on the top tray is an equimolar mixture of n-butane and n-pentane. The vapor from (he top (ray....

Conditions for the top tray of a distillation column are as shown in Figure 7.46. Determine the column diameter corresponding to 85% of flooding if a valve tray is used. Make whatever assumptions...

For each hydrocarbon spectrum, determine whether the compound is an alkane, an alkene, an alkyne, or an aromatic hydrocarbon, and assign the major peaks above (to the left of) 1600 cm-1. More than...

(35 pts) You are part of a team tasked with designing an absorption column in an oil refinery. The team has tasked you to determine the flooding velocity (ft/s ) and column diameter (ft) for the...

Expert Q&A hello please work out homework for me , please number each question and write clear as possible using BEARD MARIANNA J Numbers. Homework Problems for the Chapter10, CENG 380 Sprig 2022 Due...

5-43C Consider an adiabatic turbine operating steadily. Does the work output of the turbine have to be equal to the decrease in the energy of the steam flowing through it? 5-44C Consider an air...

hello please work out homework for me , please number each question and write clear as possible using BEARD MARIANNA J Numbers. use Beard Marianna J numbers to complete! htial akar . The tead as as...

Please work problem 2. Problem 1. Your job is to design a sieve tray column to distill a mixture of dichloromethane, chloroform, and carbon tetrachlonide. The feed is a saturated liquid at a flow...

Repeat Problem 10.D9, part a only, except at $1.50 \mathrm{~atm}$. The Antoine equation constants to determine the vapor pressure of methanol are in Table 2-3. Other physical properties are in...

Given a warehouse that serves only the five products described below, calculate the cubic feet required for a warehouse. Round up to the nearest 5,000. Assume: 30-day inventory 15 percent buffer for...

1. Ofarrell Corporation, a company that produces and sells a single product, has provided its contribution format income statement for March. Sales (6,500 units) $442,000 Variable expenses 312,000...

Distinguish between the interpretations of the direct labor and variable overhead efficiency variances.

In order to recruit Chinese employees in a competitive job market, we have to promise big year - end bonuses. Is this correct?

An aluminum pan whose thermal conductivity is 237 W/m-C has a flat bottom whose diameter is 20 cm and thickness 0.6 cm. Heat is transferred steadily to boiling water in the pan through its bottom at...

High-temperature reservoir at Ty= 652C Qu=500 kJ 5.2.1 A Carnot heat engine receives 500 kJ of heat per cycle from a high-temperature source at 652C and rejects heat to a low-temperature sink at 30C....

5.1.1 Heat is transferred to a heat engine FURNACE from a furnace at a rate of 80 MW. If the rate On= 80 MW of waste heat rejection to a nearby river is 50 MW, determine the net power output and the...

A 50.0-g copper calorimeter contains 250 g of water at 20.0C. How much steam at 100C must be condensed into the water if the final temperature of the system is to reach 50.0C? Note: Water Latent Heat...

Suppose we have a 2D array M: } } { a) Write an algorithm to traverse this array and make a pair of brackets : Hint: [), {}, () b) Write a separate logic in a form of algorithm, as you get a bracket...

Are there any spending amounts or items that you might consider reducing or eliminating?

Many consumers, particularly those in developing countries, are concerned about the cleanliness of municipal water for human consumption. For this reason, distilled water is widely available at work,...

Example 5.5 shows how to determine the rotor rotation speed and its gap width to produce emulsion particles $5 \mu \mathrm{m}$ in diameter. If it is decided that the emulsion particle diameter...

One of the tasks in a product development project is to source the ingredients. Identify a supplier and the cost for the following ingredients: (a) Zinc oxide nanoparticles under the trade name...

(Multiple Choice) - must show work for each question on this part, including the formulas you use to arrive at the answer, if any. 7. The test scores for the Law School Admission test (LSAT) in a...

Statistics Question A Statistics professor has observed that for several years students score an average of 114 points out of 150 on the semester exam. A salesman suggests that he try a statistics...

Which one of the following is not a reason to create large financial holding companies? Financial holding companies Multiple Choice offer a wide array of services under one brand name need only one...