Glass as a waste encapsulant. The encapsulation of waste in glass is considered to be a promising solution to the problem of low-level nuclear waste. A study was undertaken jointly by the Department of Materials Science and Engineering at the University of Florida and the U.S. Department of Energy to assess the utility of glass as a waste encapsulant.*

Corrosive chemical solutions (called corrosion baths) were prepared and applied directly to glass samples containing one of three types of waste (TDS-3A, FE, and AL); the chemical reactions were observed over time. A few of the key variables measured were y = Amount of silicon (in parts per million) found in solution at end of experiment (This is both a measure of the degree of breakdown in the glass and a proxy for the amount of radioactive species released into the environment.)

x1 = Temperature (°C) of the corrosion bath x2 = 1 if waste type TDS@3A, 0 if not x3 = 1 if waste type FE, 0 if not

(Waste type AL is the base level.) Suppose we want to model amount y of silicon as a function of temperature 1x12 and type of waste 1x2, x32.

a. Write a model that proposes parallel straight-line relationships between amount of silicon and temperature, one line for each of the three types of waste.

b. Add terms for the interaction between temperature and waste type to the model from part a.

c. Refer to the model from part

b. For each type of waste, give the slope of the line relating amount of silicon to temperature.

d. Explain how you could test for the presence of temperature–
type-of-waste interaction.