Create a network design to support the following:

• 10 student end devices
• 1 instructor end device; a server is preferred.
• Add access to and from a remote administrative server for video presentations and pushed updates for network application software.
• Also each student end device should have a static ip address and default gateway address along with a subnet address.
• A default gateway must be programmed on both the switch and the router.
• Router given IP addresses and subnet mask
• VLAN 1 on switch should be configured with IP address
• Document your addressing for the LAN router, switch, and 10 PCS in a table I just need help with the addressing table! Picture is how the network will be setup. I need the IP Addresses, Subnet Masks and Default gateways of the devices pictured if you were to set this up statically using IPV4. I have started the table below but not sure how to do it!?

Device	Interface	IP Address	Subnet Mask	Default Gateway
R1		192.168.1.1	255.255.255.254
		192.168.1.2	255.255.255.254
R2		192.168.2.1	255.255.255.254
		192.168.2.2	255.255.255.254
Cloud		192.168.5.1	255.255.255.254
		192.168.5.2	255.255.255.254
SW-1		192.168.3.1	255.255.255.254
S1		192.168.4.1	255.255.255.254
S2		192.168.3.2	255.255.255.254
PC-1		192.168.3.3	255.255.255.254
PC-2		192.168.3.4	255.255.255.254
PC-3		192.168.3.5	255.255.255.254
PC-4		192.168.3.6	255.255.255.254
PC-5		192.168.3.7	255.255.255.254
PC-6		192.168.3.8	255.255.255.254
PC-7		192.168.3.9	255.255.255.254
PC-8		192.168.3.10	255.255.255.254
PC-9		192.168.3.11	255.255.255.254
PC-10		192.168.3.12	255.255.255.254

PC3 PC4 Router1 PCS Cloudo RouterO PC1 Switch0 PC6 PC7 Servero PC8 PC3 PC4 Router1 PCS Cloudo RouterO PC1 Switch0 PC6 PC7 Servero PC8