MIND VERSIT D'OT Problem 3: a) S (7 pts) A 10-mm fillet weld is applied on both vertical sides of the bracket shown in the figure below. Question 12) Find the throat area A and the polar second moment of area of the weldment. Both will depend on the unknown height / of the bracket. Question 13) Find the orientation and magnitude of primary shear stress and secondary shear stress 7" at the critical locations. Question 14) Combine the primary and determine the overall critical location. Question 15) Find the required 72 cou ermi Le matriel que vous d'auteur et ne devrait t autres sites " Yous n'avez pas la plait consul N/~ secondary shear stresses into the total shear stress and the bracket if an E6010 electrode with Sy = 345 MPa is used with a safety factor of 2. Question 16) What other calculation(s) is (are) necessary to confirm the sizing of this joint (do not do them)? Vo za boooodooobooo000 larific rger 50 mm for thos nly. ebsite 150,000 N steady 10 mm fillet, both sides otect permis cla b) Explain your problem-solving approach and solution steps in a paragraph. approach, and solution LE DROIT D'AUTEUR UNIVERSIT D'OTTAWA - CONTENU PROTG (3 pts) MATERIAL UNIVERSITY OF OTTAWA - COPYRIGHTED