This is a subjective question, hence you have to write your answer in the Tent. Flatid given below. The outside diameter of a part used in a gear assembly is known to be normally distributed with a mean of 40mm and standard deviation of 2.5 mm. The specifications on the diameter are (36,45), which means that part diameters between 36 and 45mm are considered acceptable. The unit cost of rework is $0.20, while the unit cost of scrap is $0.50. If the daily production rate is 2000 , what is the totai daily cost of rework and scrap? 5M Standard Normal Probabilities Table entry for z is the area under the standard normal curve to the left of z