Question: What are the advantages of using host specific method over network specific method in the routing table? What do you understand by the term default

What are the advantages of using host specific method over network specific method in the routing table?
What do you understand by the term default routing? Is default routing necessarily a static route?
What do you understand by the term static null route? Why would you such a route?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

Topology Assessment Objectives Part 1: Develop the IPv4 Address Scheme (20 points, 25 minutes) Part 2: Initialize and Reload Devices (10 points, 10 minutes) Part 3: Configure Device IPv4 and Security...

Q:

PLEASE HELP WITH THIS NETWORKING LAB PRACTISE Addressino Table Part 1: Open the prepared Packet I racer simulation file (from Part I). Part 2: Configure Single-Area OSPFv2 (Ignore all the red font...

Q:

Cisco Networking Academy Mind Wide Open Lab 1.5.2: Basic Router Configuration Topology Diagram 192.168.1.0/24 192.168.2.0/24 192.168.3.0/24 PC1 Fa0/0 S0/0/0 DCE S0/0/0 Fa0/0 PC2 ----- R1 R2...

Q:

Exp02. Internet Protocol (ARP) Purpose 1. Learn the message format of IP datagrams 2. Learn IP checksum calculation method 3. Learn subnet mask and route forwarding 4. Understand the meaning of a...

Q:

Exp02. Internet Protocol (ARP) Purpose 1. Learn the message format of IP datagrams 2. Learn IP checksum calculation method 3. Learn subnet mask and route forwarding 4. Understand the meaning of a...

Q:

Chapter 8 Routing 1. On a TCP/IP network, a router determines where an incoming packet should go by looking at the packets __________. A. destination MAC addresses B. destination IP addresses C....

Q:

Section Two Routing Tables You may be wondering how a host or router determines where to transmit an IPv 4 packet, especially because any particular network can contain dozens, hundreds, or thousands...

Q:

Follow the submission instructions for each exercise and ensure that you meet the deadline, use the correct submission process and submit your work to the correct place. For some laboratory tasks you...

Q:

please make a small summary PowerPoint slides about this chapter below "Staffing, Recruitment and selection" also in international compamy. urgent please CHAPTER 5 SOURCING HUMAN RESOURCES FOR GLOBAL...

Q:

How does routing work? Routers refer to internal routing tables to make decisions about how to route packets along network paths. A routing table records the paths that packets should take to reach...

Q:

What five factors are compensation policies usually based on? Name three employee benefits that are required by law. Name three employee benefits that firms often provide voluntarily.

Q:

Sam & Sons Ltd. purchased machinery on September 30, 2023, at a total cost of $46,500. Sam estimated the useful life of the machinery to be eight years or 50,000 hours, with an estimated residual...

Q:

Why would a company want a minimum cash balance? Suppose that the minimum cash balance is $1,000 and that the projected cash surplus is $500. What would a company have to do to achieve the desired...

Q:

Compared with half a century ago, adoption has become _ _ _ _ _ _ _ _ _ common, but it is more open and acceptabl e , so we probably discuss it _ _ _ _ _ _ _ . fill in the blanks more or much less or...

Q:

Why is the System Build Process an iterative process?

Q:

What phase normally comes directly after the System Build process in a Project?

Q:

Name two other algorithms available in SSAS Data Mining other than Decision Trees.